Elite The Protector El manual del propietario descargar pdf (Pagina 10)

Alarm Sirens

Exterior and interior sirens make 3 different alarm sounds

on the premises, each indicating a different type of alarm.

Sirens are programmed by the installer to time-out and

stop sounding after a specified time.

Use the following table to understand the siren sounds

used by the security system. Temporal 3 refers to a contin-

uous pattern of 3 siren pulses then off for 2 seconds, 3

siren pulses then off for 2 second.

Panel Indicator Lights

Use the following table to understand the panel indicator

lights.

Guidelines for Preventing Accidental

Alarms

The following guidelines will go a long way toward pre-

venting accidental alarms.

• Close doors and widows before you leave your house.

• Gather your belongings, so you can exit immediately

after arming the system.

• Always enter and exit within the programmed delay

times.

• Disarm your system immediately upon returning home.

• Be aware of the devices in your security system and learn

how each one operates.

• If you have pets, ask your installer if you need pet lenses

in your motion detectors.

• Check the location of your smoke detectors. Smoke

detectors near bathrooms and kitchens can be tripped by

steam and smoke from cooking.

• Take note of system beeps, voice announcements and

indicator lights which indicate the current system status.

How to Use an Off-Site Phone

You may use an off-site phone to arm/disarm your panel,

check system status, or conduct an audio session (ask your

installer if you have this feature).

How to gain access to the Control Panel:

1. Call the panel and let the phone ring twice then hang

up.

2. Wait at least 10 seconds and call the panel again. You

may wait up to 40 seconds before calling again.

3. The panel should answer on the first ring. You won’t

hear any prompt when the system answers.

4. Press the * button on your telephone and you will hear

system activated.

At this point you may perform the actions listed in the fol-

lowing table of phone commands. CODE refers to the

master and access codes programmed into your system.

ARM

Doors/

Windows

& Motion

Sensors

Exit delay

and

Entry delay

beeps sound 4

times every 5 seconds and 4 times per

second during the last 10 seconds (if Silent

Exit is used, the Exit delay beeps will only

sound 4 times when you arm and 4 times

when the Exit delay expires)

DISARM 1 beep

CHIME

DOORS

2 beeps (feature must be programmed by

installer)

CHIME

SPECIAL

MOTION

3 beeps (feature must be programmed by

installer)

Alarm Sirens

Alarm

Type

Interior

Siren

Sound

Exterior

Siren

Sound

Fire Temporal 3 Temporal 3

Intrusion On steady On steady

Emergency Fast on-off ________

Panel Indicator Lights

Button

When the

Button Light is

When the Button

Flashes

Arm Doors

& Windows

Doors/Windows

armed

Doors/Windows

armed & No Entry

Delay on

Arm Motion

Sensors

Motion Sensors

armed

_________________

Disarm System disarmed System subdisarmed

System

Status

System trouble or

Open Sensor

System in alarm

Chime

Doors

Door will cause

chime

_________________

Status Beeps

Chime

Special

Motion

Motion will

cause chime

_________________

Panel Indicator Lights

Button

When the

Button Light is

When the Button

Flashes

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comentarios a estos manuales

Sin comentarios

Elite The Protector El manual del propietario Pagina 10

Comentarios a estos manuales