
Elite Learning Universal Remote Control – R800D
Press and hold the ALL OFF key about 2~3 seconds and then release them. The remote control will send out all
current power signal to turn on(or turn off) for every device one by one. Meanwhile the device key flashes to tell you
which power signal is been sending.
Remark: The remote control must be pointed to device that you like to control until the operation finished.
☆11:Macro Function
Macro function let you make sequent operation for you home theater. Press and hold the MACRO key and digital
nember 1 key ( or 2,3 key), and then release them. The device LED will flash and the remote control will send out a
sequent IR commands that you programmed before.
You can set up a Macro by following below steps:
1. Press and hold the SET key for more than 3 seconds, then release it.
2. Press the or key to select MACRO in the LCD menu, and then press the OK key.
3. Press the or key to select the MACRO1 in the LCD menu (or Macro2 or Macro3), then press the OK key.
4. The screen shows SETUP, and then press the OK key.
5. You can select the device and function key for a sequent operation that you like. (e.g.: TV+POWER+MUTE+AV,
DVD+PLAY, VCR+RECORD, etc. That means you want turn on the TV and shut off it’s sound, switch TV input to AV
port, at the same time DVD start to play disc, VCR begins to record )
6. Press the OK key to save the setting, LCD shows SUCCESS then exit to current setup state,
7. You can press any device key to finish set up or press the EXIT key to last state and use or to select
other set up.
Comentarios a estos manuales